Keck 12-60×60

There’s a few people at club not happy with theres and are returning them 🥴
I looked through a pals today and seriously it was shocking! Could not get a clear sight picture no matter what and as you turned elevation clockwise (down) you could see the inner bell coming into the bottom of the sight cutting off the view .! it’s going back needles to say

Mine on the other hand is really rather good 🤷🏻‍♂️

Did you remove the zero stop? I found the same with mine, until I removed it and got the full range of adjustment.
 
Not to happy with mine used it yesterday sight picture cloudy seems top half above reticle is clearer than bottom half and will not parallax at 25 yards very disappointed with this having had a look though the one in the review it was much better. the sentinel-x pro will be going back on tm1000 today

Just a guess, it might be the zero stop? Upon receipt I found a similar issue, until I removed the zero stop collar and adjusted everything properly.
 
What would removing the zero stop do ? You should be able to use all elevation travel both ways without seeing the inside of the objective bell coming into view
 
What would removing the zero stop do ? You should be able to use all elevation travel both ways without seeing the inside of the objective bell coming into view

Mine was set at the bottom or the top of the range (can't remember which) so when adjusting the elevation I quickly ran out of adjustment and could see the bell coming into view. Perhaps not the bell, but I lost part of the lower/upper portion of the reticle. I spoke with Matt and he told me about the zero stop, which apparently he berated the factory over.
 
So, after a thorough session with the Keck yesterday, and another very critical eye, courtesy of an OCD friend, mine's s good 'un. Not as sharp as my Falcon T50i, but not 'night and day'. Let's not forget, this is not a direct competitor to the Falcon, afterall, it is £150 - £200 cheaper.

I would pitch it as a hugely improved Minotaur.
 
Back
Top