Kalibrgun
Super member
Has anyone got dimensions of a p15 valve stem so I can get a couple made ?
-
the Daily hi thread
Valve stem dimensions
- Thread starter Kalibrgun
- Start date
I actually need one myself so if you managed to get the measurements and have some made will you able to provide me with one?
rmpc50
Member Extraordinaire
I've got one here that I've been saving for a rainy day.
Difficult to measure the angle of the seat, but about six months ago I turned up a spare brass transfer port, and I'm pretty sure that I remember setting the compound at 30 degrees to cut the seat.
One day I might even get round to making some myself, but I've got quite a lot on at the moment. Hope that helps.
you won't happen to know where to get one, I tried to get one and can't find any anywhere
rmpc50
Member Extraordinaire
Sorry mate can't help you, I bought the one I have about two years ago from Bagnall & Kirkwood, but they're out of stock at the moment.
No worries, tried B&K bit been out for ages and not seen to going to replenish. Thank you for letting me know ow anyway and at least I got measurements now should I find someone that can fabricate one. Thanks again