I removed my TNT Thermnight from my HW100KT to do some maintenance on my rifle, when I put the scope back in exactly the same place Intook it off from which I had marked to make sure it went back in the same place, now I expect to rezero after removing a scope and putting it back, but this was miles off It when shooting I had tried everything and couldn’t make zero and after a few hours pulling my non existent hair out, I went on line to see if I could find the issue, oh I found it lol for the life in me I don’t know why I was doing this, I was freezing the crosshairs on the pellet marks and then adjusting to the bull of the target, the completely wrong way round, I have zeroed hundreds of times so can only blame it on a senior moment, it’s now perfect again but talk about being a wally.
-
the Daily hi thread
Thermnight 225R Zero troubles
- Thread starter Carlos65
- Start date
Hollowlegs
Super member
So easily done worse of it is you are sure it’s right at the time
. At least you sussed it, and admitted to it publicly 
Hollowlegs
Super member
So easily done worse of it is you are sure it’s right at the time