junglie2022
Member Extraordinaire
I've used hempseed oil for over 20 years with no problems but if I get an old gun with motor oil soaked seal I degrease them first before I do it. I much prefer it to other oils though I imagine coconut oil is ok in spain where it'sNeatsfoot oil is the thing realy. Castor oil is ideal if they are sat a long time and harden any which happens if folks have used car mineral oils or olive oil.
Hempseed oil.... new one on me that probably be fine as long as it dont congeel and gum up. You end up with a rancid sticky mess with olive oil.
Mate mentioned cocanut oil again never used it just castor or neatsfoot. Seen lads use 3 in one back in the day they smoked bad i remember.
Basocly stick to neatsfoot if you can get it and castor if real hard or sat a long time. . This is down port.
If you are stripping it . Saddle soap proberts. Leave it dry then when dry soap in neatsfoot 12 hours then build it up wipe what you xan off the ezess neats foot then build up wile supple.
Then what i said afore.
Hotter than here. I use very little to soak old dry washers, just coat them & wrap on a layer of cling film then insert into the end of cylinder overnight till it soaks in. This stops the seal swelling too much to fit easily , obviously remove the cling film before reassembly though. I still use a smear of moly on the rear of pistons & springs & also dry slide the cylinder walls & front of piston . I get very little dieslling if any after this treatment.
