• the Daily hi thread just say hi :)
  • Welcome to the UK's Most Active Airgun Forum

    Looking for expert advice on air rifles and shooting gear? You have found the internet's premier independent airgun forum. Our active shooting community shares daily technical insights on modular PCP air rifles, spring-powered rifles, air pistols, pellet testing, and optics setup. Whether you are troubleshooting an FX or Daystate regulator, discussing legal FAC requirements, planning a night vision hunting trip, or looking for pest control tips, our members are here to help.

Best matrial to stop a pellet

mattmiles1989

Proactive member
Joined
Mar 24, 2023
Messages
308
Reaction score
329
Points
143
Location
South wales
Hi
I use a box when using my chronograph to catch the pellets after it goes through my lmbr chronograph. I was using a argos catalogue for years with great success no pass through but always had bits of paper scattered after to clean up. So I put a yoga block (foam) and another bit of foam In the box and had a complete pass through at 5.4ftlb pistol so any recommendations paper works but cleaning up bits all the time is annoying cheers
 
I have heared good things about plumbers putty but how think would that need to be to stop a sub 12 at less than a foot away
 
have you seen the huben owner on you tube he is using a cut down gas bottle with chain hanging on the inside, seems to work ok, but my mate uses a box stuffed with old clothes and he said that works for him.
 
I used to use a box with old magazines and catalogues, but as said it starts to shred small pieces of paper after a while. I now use a box full of old clothes and rags, it also includes some net curtain. I have an old quilt on standby when it needs replacing
 
I use it in the garden I now have a .177 buried into my shed door after the pass through 😆
 
  • Like
Reactions: Obi
Did the same. Every now and then I torch the pellet build up and the surface smooths out nicely. I built it a year ago now and it’s beginning to get bloody heavy. Pinched the idea from Mr Tilley
Had mine some years now.
I just break the lead build off up and throw it in a container for remelting at some point
Every time I remelt mine, it does get heavier
 
Back
Top