Using Mero App - 2 questions.

1) In the Projectiles menu there is no JSB Jumbo RS .22 shown. Instead, I have selected RWS superdome but have changed the weight from 14.50g to 13.43g and ballistic coefficient from 0.160 to 0.023 which I found online. Is this ok or is there a better way of inputting the correct pellet?

2) In the Reticle Display Options section there is a part which says ‘Setup: Dots@ Target (50 yards)’ and options between ‘0.5 and 5.0 dots at target’. I’m not sure what this means and what figure to use. My scope is a Hawke Vantage 4-16 x 50 ao ir. Can anyone please explain or help with what I should enter here. TIA.

Perhaps @BallisticBill can assist.

To explain my problem, I have Mero installed on my Android phone and android tablet. With the same figures put in both devices each device shows different holdover dots. I don’t recall having input the figures 2.2 or 1.5 in the Reticle Setup section or whether either are correct. Sorry if I’m a bit thick, but what figure should be input to get correct holdover?
I’m tagging @HarrysLad @Ballisticboy and @BallisticBill in case they miss the original post.
Thanks guys and apologies again if I’m being thick and missing something which should be obvious

1) a better way would be to copy/clone an existing (0.22) pellet and edit the name, weight and BC of the copy to suit.

2) the "Setup: Dots @ Target" item is connected to the "Indicated Mag." (tap the orange label to toggle the value between "Indicated Mag" and "Calibration Mag."). The "Dots @ Target" values are different because the "Indicated Mag." values are different (and vice versa) on the two devices.

Also note that the app doesn't do calculations with every change of parameter. You need to tap the enter key to initiate a re-calculation.

HTH
Dave

HarrysLad said:

1) a better way would be to copy/clone an existing (0.22) pellet and edit the name, weight and BC of the copy to suit.

2) the "Setup: Dots @ Target" item is connected to the "Indicated Mag." (tap the orange label to toggle the value between "Indicated Mag" and "Calibration Mag."). The "Dots @ Target" values are different because the "Indicated Mag." values are different (and vice versa) on the two devices.

Also note that the app doesn't do calculations with every change of parameter. You need to tap the enter key to initiate a re-calculation.

HTH
Dave

Click to expand...

Thanks Dave, I hadn’t realised that there was a toggle between Indicated and Calibration Mags.
Thanks again for your advice and explanations