Deejayuu

Bit dim here but was the HW cylinder 'exhaust' valve still in place please?

Well chaps, from the end of this month I am stepping down as a moderator on this fine forum. My fellow mods are aware and I just wanted...

Your photos show a sleeve around reg. piston. Early, Mk1?, didn't have that.

21.7 mm is a tight push fit here!! For info. the 25 mm and 95 are the same

Are you selling the original reg. please?

Granny/eggs. There's three of those, similar, springs as found. One for fill port check valve, another under reg. ball and, as Blackmax...

Of course, the person writing this shoots from a standing position at targets between 15 and 25 meters away, with the rifle supported on...

I would remove the valve body then measure depth of the regulator inside the cylinder. Next remove regulator and place against outside...

https://airgunforums.co.uk/threads/hw95-world-beater.78968/unread

Local RFD had a second hand one with three mags. Can check when they open later.

Just saying hello from the U.S. I’m new to this forum but am on Airgun Nation in the U.S. I understand that the rules and regulations...

I got it apart, a little heat and leverage. It doesn't have a slot for a screwdriver

Just here that confused me.

No joint lines. Probably just low quality of photo, I've reduced image size on them all due to forum data space filling up.

Lovely work as usual. Bit dim here, is that a joint line on photo one?